Main Article Content

Formulation and Permeation Kinetic Studies of Flurbiprofen Gel


RK Ayoub
G Murtaza
M Imran
SA Khan
S Mir
AK Khan
S Azhar
Z Mehmood
A Sajjad
SNH Shah

Abstract

Purpose: To investigate the in vitro permeation and drug release kinetics of flurbiprofen gel.
Methods: Thirteen batches (G1, G2 … G13) of flurbiprofen gels were prepared using different ratios ofpermeation enhancers, i.e., propylene glycol (PG) and polyethylene glycol (PEG), by response surface methodology (RSM). Viscosity, pH, spreadability, consistency and drug content of the flurbiprofen gels were measured. Permeation experiments were conducted using silicone membrane in a modified Franz diffusion cell. Permeation parameters determined include diffusion coefficient (D), Flux (J), lag time (tLag), permeation coefficient (Kp), input rate (IR) and enhancement ratio (ER). Primary skin irritation test was performed for the optimized gel, G3, using 11 human volunteers.
Results: Maximum solubility (72.15 ± 0.02 mg/mL) of flurbiprofen was observed in a mixture (2:1) of methanol and water. Partition coefficient (Ko/w) was determined as logP = 3.68 ± 0.11. The gels were stable under various storage conditions, and were homogenous, crystalline and transparent. Viscosity, pH, spreadability, consistency and drug content were in the range of 150 – 178 × 102 cps, 5.42 - 5.75, 5.0 - 7.0 g.cm/s, 3.0 - 9.0 mm, and 97.99 - 99.86 %, respectively. No irritation or lesions (erythma, redness and ulceration) occurred in human volunteers over a 30-day period. The optimized formulation, G3, showed maximum flux through silicone membrane.
Conclusion: PG and PEG are effective enhancers of flurbiprofen from  various formulations when used in various ratios.

Keywords: Flurbiprofen, Gel, Diffusion, Permeation enhancers, Skin irritation, Silicone membrane


Journal Identifiers


eISSN: 1596-9827
print ISSN: 1596-5996