Article Sidebar
Published:
Oct 3, 2012Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
An Extended Octagonal Ring Dynamometer for Measurement of Forces on a Simple Tillage Tool
Abstract
The analysis, design, construction, evaluation and use of an extended octagonal ring dynamometer for measurement of draught, vertical force and moment on a simple tillage tool are presented. The dynamometer was used to measure tool forces as functions of depth, rake angle and speed, for a wide plane blade.
The dynamometer was designed for a maximum draught of 4.4 kN, vertical force of 4.0 kN and moment of 2.2 kN-m. Evaluation and calibration showed linear response (R2 = 0.99 to 1.00) for the relationship between applied load and output voltage and no hysteresis effect within the load range was observed. Actual sensitivity obtained were 0.332 m V/N.V for draught, 0.726m V/N.V for vertical force and 2.5 m V/N-m.V for moment. Maximum cross sensitivity was less than 6%. The dynamometer showed expected response of tool forces as affected by tool depth, rake angle and speed.
