Article Sidebar
Published:
Nov 15, 2018DOI:
10.4314/njt.v37i4.29Keywords:
Article Details
Copyright belongs to the Faculty of Engineering, University of Nigeria, Nsukka, Nigeria
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from https://www.nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in Statement of Originality.pdf (nijotech.com)
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
Main Article Content
Clean energy generation using groundnut oil mill effluent with microbial fuel-cell
Abstract
Microbial system that converts organic matter to energy is proposed in this paper. An attempt is made, to examine the potential of using groundnut oil mill effluent (GOME) as substrates to Microbial Fuel Cell (MFC). A methodology was developed to obtain a power density in batches by varying the feed rate of continuous flow in the MFC. The results obtained show that GOME produces higher energy per unit area compared to other mixed culture reported in scientific literatures. The minimum and maximum power densities obtained are 160 mW/m2 and 217 mW/m2 at low feed rate of (400 litre/hr) with cell potential of 625 mV and high feed rate of (420 litre /hr) with cell potential 727 mV respectively. Furthermore, the findings of this research work showed that MFC could produce higher power density at continuous flow process mode (160 mW/m2) compared to batch process (54 mW/m2). Thus, this study demonstrates the potential of generating clean energy via GOME, with by-products of carbon dioxide and water.
Keywords: Clean energy, Fossil-fuel, Renewable energy, Fuel-cell, Groundnut Oil Mill Effluent (GOME)
